|Hot Tools Clip & Groom
Blades for: Callsic Pro
Magnetic Motor Clipper HTC7001RB
To remove the blades, unplug the clipper from the electric outlet. Lay the unit upside down on a flat, dry surface. Remove the two screws located in the bottom blade.
To replace the blades, put the new top blade into position on the clipper head. Make sure the adjustable lever is pushed downwards. Line up the new bottom blade so that the screw holes in the bottom blade are directly over the two center screw holes in the mounting plate. Replace the screws. Before tightening screws, adjust the position of the blades so that the top blade is 1/32" back from and is parallel to the front edge of the bottom blade. The blades should also be even on each side. Tighten screws firmly.