- Item#: 6940
- UPC: 040102180408
Andis Ultra 22 Piece Home Haircutting Kit
Model Number: #18040
The Complete Home Haircutting Kit for the Entire Family.
. (1) Andis Powerful, Magnetic Motor Clipper
. (1) How To Video for Easy to Folllow Cutting Instructions
. (10) Attachment Combs (1/16 inch, 1/8 inch, 1/4 inch, 3/8 inch, 1/2 inch, 3/4 inch, 1 inch, Blending . Comb, Left Taper and Right Taper)
. (1) Durable Hard Plastic Storage Case
. (1) Neck Cleaning Brush
. (1) Barber Cape
. (1) Styling Barber Comb
. (1) Tapered Barber Comb
. (1) Stainless Steel Shears
. (1) Blade Cleaning Brush
. (1) Protective Blade Guard
. (1) Lubricating Blade Oil
. (1) Step by Step Instructions
. Easy to use, save money, Convenient
. The complete home haircutting kit for the entire family
. 22 piece Home haircutting kit
careful workmanship and quality design have been hallmarks of Andis Product since 1922.
Keywords: andis ultra 22 piece home haircutting kit
Please read thefollowing instructions before using your new Andis Clipper. Give it the care that a fine precision built instrument deserves and it will give you years of service. before starting clipper remove blade guard. Current or as into electrical outlet, operate at 120 volt, 60 cycle AC electrical current or as noted on the unit. to start clipper move switch button forward, to stop, move switch button back to original position. After using your Andis clipper, rewrap cord and store in a safe place.
USER MAINTENANCE: Other than the recommended maintenance described in this manual, no other maintenance should be performed, except by Andis Company or an Andis Authorized Repair Station.
POWER ADJUSTMENT: Your Andis Clipper has been adjusted to line voltage at the factory. However, beacuse of voltage cariations it may be necessary to adjust the power setting for your area. if the power adjustment is off, you will usually notice a "clatter" when the clipper is "on" or introduced into the hair. (It is normal for your clipper to "clatter" for an instant when initially turned on).
TO ADJUST YOUR CLIPPER:
1. Oil the blades (Diagram A)
2. The power screw is located in the lower part of the housing opposite the switch (Diagram B).
3. Turn your clipper "on"
4. Using a standard screwdriver that fits the slot, turn the power screw clockwise untilthe clipper clasters continuously. Then turn the screw counterclockwise carefully until the clatter ceases.
5. Your clipper is now adjusted to its optimum power setting.
CARE AND SERVICING OF YOUR ANDIS CLIPPER BLADES: Blades should be oiled before, during, and after each use. If your clipper blades leave steraks or slow down, it's a sure sign blades need oil. The clipper should be held in the position shown in Diagram C to prevent oil from getting into the motor. Place a few drops of Andis Clipper Blade Oil on the front and side of the cutter clades (Diagram A). Wipe excess oil off blades with a soft dry cloth. Spray lubricants contain insufficient oil for good lubrication, but are an excellent clipper coolant. Always repalce broken or nicked blades to prevent injury.You can clean the excess hair from your blades we suggest to immerse the blades only into a shallow pan of Andis Clipper blade Oil, while the clipper is running. Any excess hair and dirt that has accumulated between the blades should come out. After cleaning, turn your clipper off and dry blades with a dry cloth and start clipping again.