Andis Styliner II TRIMMER - # 26700

Andis Styliner II TRIMMER - # 26700

Andis Styliner II TRIMMER - # 26700

New Improved design!

Powerful trimmer for outlining and final shaping. Equipped with wide close-cutting T-blade contoured hosing with convenient side switch. Fine-cutting teeth for extremely close cutting. High-quality carbon-steel blades specially hardened for long cutting life. Excellent for dry shaving, powerful magnetic motor runs cool and quiet. Heavy-duty 8-foot cord with hanger loop.

. Equipped with wide close-cutting T-Blade

. Exvellent for dry shaving

. Powerful magnetic motor runs cool and quiet

. Heavy-duty 8-foot cord with hanger loop

Congratulations! You just went first class when you bought this Andis product. careful workmanship and quality design have been the hallmarks of Andis products Since 1922.

Replacement (Removal) of Blade Set For Model SLII and SL3: Your Andis SL II

Keywords: andis styliner ii trimmer

Please read the following instructions before using your new Andis Trimmer. give it the care that a fine precision built instrument deserves and it will give you years of service. Before starting trimmer remove blade guard. Plug cord into electrical outlet, operate at 120 volt, 60 cycle AC electrical current or as noted on the unit. To start trimmer move switch button to on position, to stop, move switch button back to original position. After using your Andis trimmer, rewrap cord and store in a safe place. Some of the "basic" uses for a trimmer are illustrated below.

USER MAINTENANCE: The internal mechanism of your trimmer has beem permanently lubricated at the factory. other than the recommended maintenance described in the manual, no other maintenances should be performed, except by Andis Company or an Andis Authorized repair service station.

Power Adjustment for For Model SLII and SL3: Your Andis trimmer has been adjusted to line coltage at the factory. However because of voltage cariations it may be necessary to adjust the power setting for your area. if the power adjustemtn is off, youwill usually notice a "clatter" when the trimmer is "on" or introduced into the hair.

To Adjust Your Trimmer:

1. Oil the blades

2. The power screw is located in the lower part of the housing opposite the switch

3. Turn your trimmer "on"

4. Using the standard swrew driver that fits the slot, turn the powescrew counter clock-wise until the trimmer clatters continuously. Then turn the screw clockwise carefully until the clatter ceases.

5. Your trimmer is now adjusted to its optimum power setting.

Care and Servicing of Your Andis Trimmer Blades: Blade should be oiled before, during, and after each use. If your trimmer blades leave streaks or slows down its a sure sign blades need oil. The trimmer should be held in a position shown to prevent oil from getting inot motor. Place a few drops of Andis Trimmer Oil on the front and side of the cutter blades. Wipe excess oil off blades with a soft dry cloth. Spray lubricants contains insufficient oil for good lubrication, but are an excellent trimmer coolant. Always repalce broken or nickeed blades to prevent injury. You can clean the excess hair from your blades by using a small brush or worn out tooth brush. To clean the blades we suggest to immerse the blades only inot the shallow pan of Andis trimmer Oil, while the trimmer is running. Any excess hair and dirt that has accumulated between the blades should come out. After cleansing, turn your trimmer off and dry blades with a dry cloth and start clipping again.