Andis IMPROVED MASTER Clipper / Recortadora # 01557

Andis IMPROVED MASTER Clipper / Recortadora # 01557



Andis IMPROVED MASTER Clipper / Recortadora # 01557

Convenient, thumb-controlled side switch for one-hand on/off operation. Unbreakable, lightweight aluminum housing.

. Perfect for all-around cutting and tapering.

. High-speed motor runs quiet and cool.

. Unbreakable, lightweight aluminum housing.

. Powerful megnetic motor generates 14,000 cutting strokes per minute.

. Designed for heavy-duty haircutting

. Perfect for all-around cutting and tapering.

Congratulations! You just went first class when you bought this Andis product. Careful workmanship and quality deisgn have been the hallmarks of Andis products since 1922.

PLEASE NOTE: Persons familiar with replacing and adjusting Andis models ML &GC blades, please read the following blade replacement instructions. Those persons not familiar with this procedure, pelase return clipper/trimmer to your supplier or A

Keywords: andis improved master clipper recortadora

Please read the following insturctions before using your new Andis clipper/trimmer. Give it the care that a fine precision built instrucment deserves and it will give you years of service. Beforestarting clipper remove blade guard. Plug cord into electrical outlet, operate 120 volts, 60 cycle AC electrical current or as noted on unit. To start clipper, move switch button to on position; to stop, move switch button back to original position. After using your Andis Clipper, rewrap cord and store in a safe place.

USER MAINTENANCE: The internal mechanism of your motor clipper has been permanently lubricated at the factory. Other than therecommended maintenance described in the manual, no other maintenance should be performed, except by Andis Company of an Andis Authorized Repair Service Station.

POWER ADJUSTMENT FOR MODELS ML & GC: Your Andis clipper/trimmer has been adjusted to line voltage at the factory. However, because of voltage cariations it may be necessary to adjust the powe setting for your area. If the power adjustment is off, you will usually notice a "clatter", when the clipper is "on" or introduced into the hair.


1. Oil the blades

2. The power screw is located in the lower part of the housing opposite the switch.

3. Turn your clipper/trimmer "on"

4. Using a standard screwdriver that fits the slot, turn the power screw counter clockwise until the clipper clatters continuously. Then turn the screw clockwise carefully until the clatter creases.

5. Your clipper/trimmer is now adjusted to its optimum power setting.

CARE AND SERVICING OF YOUR ANDIS CLIPPER BLADES: Blades should be oiled before, during, and after each use. If your trimmer baldes leave streaks or slow down, its a sure sign blades need oil. The trimmer should be held in a position shown to prevent oil from getting into motor. Place a few drops of Andis Trimmer oil on the front and side of the cutter blades. Wipe excess oil off blades with a soft dry cloth. Spray lubricants contain insufficients oil for good lubrication, but are an excellent trimmer coolant. Always repalce broken or nicked blades to prevent injury. You can clean the excess hair from your blades by using a small brush or worn out tooth brush. to clean the blades we suffest to immerse the blades only into a shallow pan of andis trimmer oil, while the clipper is running. ANy excess hair and dirt that has accumulated between the blades should come out. After cleaning, turn your clipper off and dry blades with a dry cloth and start clipping again.