Clip & Groom Trimline clipper REPLACEMENT Blade - htc7041rb
|Clip & Groom Trimline clipper HTC7041|
Blade for: TrimLine Pivot Motor Clipper
To remove the blades, unplug the clipper from the electric outlet. Lay the unit upside down on a flat, dry surface. Remove the two screws located in the bottom blade.
To replace the blades, put the new top blade into position on the clipper head. Make sure the adjustable lever is pushed downward. Line up the new bottom blade so that the screw hole in the bottom blade are directly over the two center screw holes in the mounting plate. Replace the screws. Before tightening screws, adjust the position of the blades so that the top blade is 1/32" back from and is parallel to the front edge of the bottom blade. The blades should also be even on each side. Tighten screws firmly.
|Similar items of Clip & Groom Trimline clipper REPLACEMENT Blade that you may like:|
Clip & Groom Flip Top clipper REPLACEMENT Blade - htc7003rb
Clip & Groom Classic clipper REPLACEMENT Blade - htc7001rb
Clip & Groom FineLine clipper REPLACEMENT Blade - htc7002rb
Wahl Replacement Clipper Blade - 1mm to 3mm # 1005
Print Share Share Digg This